Looking to freshen up your bike? 

We offer complete frame off builds, from restoration work to something a little wilder.

Contact us with your ideas and we will be happy to give you a quote.

New bike?

we offer a  thorough check-up to help keep surprises to a minimum.

• All accessible nuts and bolts tightened
  
• All fluids checked for condition and levels
• Timing belts inspected for tension and condition
• Tires checked for wear ,age and pressure
• Chain and sprockets checked for wear tension and alignment
• Chassis bearings checked for wear
• Wheels checked for damage
• Brake pads checked for wear
• Brake lines checked for condition
• suspension checked for leaks of damage
• charging system output test
• compression tested
• oil pressure and leak-down tests may be added
• rider controls inspected for safety

We are also happy to go over a bike that you are planning to purchase. Allowing you to be informed as to what condition the motorcycle is in, before you buy.

Seasonal check-ups

Putting your motorcycle away?  

• We will check the bike over for any items that need attention
• drain carburetors
• fog the engine
• remove the battery or install tender leads
• flush hydraulics if needed
• change oil and filter
• inspect coolant
• stabilizer in fuel
  

Or has your motorcycle been sitting for a while in storage?

We will go over the motorcycle just like it is a new bike and look for any problem areas that you should e aware of.

• timing belts inspected
• battery installed
• inspect coolant
• chassis tune (nuts and bolts)
• chain tensioned
• fluid levels checked
• air filter inspected
• motorcycle run to verify idle 

Yes, This is the big one.

• belts changed or adjusted
  
• Valves adjusted
  
• oil and filter changed
• fuel injection set up
• throttle position sensor  checked (if applicable)
  
• throttle bodies or carburetors syncronised
• air bypass screws or fuel screw adjusted
• idle set to factory specification
• electrical
• battery charged and tested
• charging system checked for output
• stator connectors inspected for heat damage
• lights, switches and horn tested
• headlight aim checked and adjusted
• spark plugs changed
• chassis
• all visible nuts and bolts checked
• chain and sprockets inspected for wear
• chain  adjusted for tension and alignment
• swing-arm pivot checked for excess play
• steering head bearings checked for play and wear
• wheels checked for bearing play
• wheels inspected for bends
• tires inspected for wear
  
• air pressures set
• brake and clutch fluid changed
• brake pads inspected for wear
• suspension units inspected for leaks and damage
• fuel filter changed
• air filter inspected and changed if neccesary
• road test
  

Planning to Take your bike to the track?

We can offer a complete check-up  to make sure you are ready to pass "tech"

• Tires checked for tread depth and wear (age also)
• Brake pads checked for wear
• Brake fluids checked
• Oil level checked
• Coolant checked
• Chain checked for tension / wear and alignment
• Steering head bearings checked
• Swingarm play checked
• Suspension seals checked for leaks
• General check over for leaks
• Throttle freeplay and action checked
• Wheel bearings checked for play
• Nuts and bolts checked for tightness (all that can be accessed)

Some track days will require you to change your coolant for water, we can swap coolant out for you. Price depends on time required, usually 1/2 hour depending on the bike.

Needing your bike safety wired? No problem, we can do that too! From oil fills and drains to complete race specification wiring.

Need to tape your bike up but  do not know how, bring the tape we'll put you to work.

Note: this is a "check-up."  if we find items that need addressing, you will be advised of our recommendations and then you will have to decide what action to take.

Repairs will be gladly done, time permitting. You will be billed additionally for any repairs.